©
XPAND
, All Rights Reserved.
6
www.xpandcinema.com
©
XPAND
, All Rights Reserved.
7
www.xpandcinema.com
Getting Started
1. Set your playback device to 3D mode.
2. Turn on your XPAND 3D glasses (refer to Picture 1) and place them on
your head. That’s it! You are ready to start enjoying your 3D experience.
Maintenance of Your XPAND 3D Glasses
Your XPAND 3D glasses represent the state of the art in high-speed optical
switching technology. With proper care they should give you many years of
trouble-free operation of 3D viewing enjoyment.
Turning On/Off Your Glasses
To turn your glasses ON lightly pass or brush your fingers along the right
side (outside) of your glasses frame over the XPAND logo (see the power
on logo). The glasses will turn off automatically after 5 minutes when they
stop receiving the stereo synchronization signal from your TV or projector.
Low Battery Warning (see also Storing your glasses, page 8)
The battery warning is intended to trigger when the battery level falls below
2.6V.
The battery level is tested when entering either the off mode or the turn on
mode. (1) If a low battery is detected when entering the off mode, the lens
will flash in an alternating pattern from one to the other at about 1 cycle per
second. (2) If a low battery is detected when entering the turn on mode the
lens will flash alternating clear three times. Since turn on is accomplished
when the lenses are dark, the light flashes are kept to a minimum. So the
flashes are only long enough to be seen; for a few seconds.
Handling
As with any optical device you should use care to prevent damage to the
optical elements of your XPAND 3D glasses. The lenses are sensitive and
can be cracked if the glasses are rotated or twisted. The glasses should
be held by the frame in order to avoid getting fingerprints on the lenses or
scratching them.
Don’t leave your XPAND 3D glasses unprotected. Store the 3D glasses
away from dust and moisture.
Avoid stressing the XPAND 3D glasses, frames, and lenses. Do not stretch
or bend the frames.
Do not scratch the lenses.
manual-BW-4x6_FAQ-new-battery-instr-v6-2PACK.indd 7
16.11.2010 16:36:56