5
V. C
ONTROLS
SENSITIVITY, POWER I/0
Turn the machine on with the SENSITIVITY I/O control.
You will hear some quick "beeps" which will tell you that the detector is
correctly operating. Then you can detect.
Good luck !
The sensitivity level adjusts the detection depth and the stability of your detector. Adjust it
according to the surroundings so that you won't be disturbed with false signals.
Avoid testing your detector inside your house or in shops because you
can encounter a lot of metallic and electromagnetic pollution
(reinforced concrete, fluorescent lights, metallic girder).
DISCRIMINATION
Discrimination allows you to mask some type of metal targets.
While turning the control, you can choose your level of discrimination
according to your needs.
Switched to All Metal position, discrimination control is deactivated,
your detector pick up all the targets, ferrous or not-ferrous. This position
will enable you to better locate the ferrous targets.
From level 1, you start to discriminate the ferrous targets.
Between level 6 and 10, you can for example reject the small aluminium foil.
Set low levels of discrimination, which will enable you to find small targets more easily.
Before the first use of your detector, familiarise with metal test targets (Ferrous / Non-Ferrous).
A non-ferrous target will produce a deep, full sound which can be repeated at the same spot
with each sweep. Most of the ferrous targets will be silent or might produce a choppy sound
(short “pops” or “clicks”) which can be easily recognised.