III. A
SSEMBLY
The assembly of your detector will only take you a few seconds.
Put the shaft together as shown on the diagram.
1. Press the 2 shafts (3) and (5) one towards the other to help the spring clips (4) locate
themselves.
2. The twist lock (6) is used to stop any movement of the fibre glass stem in the aluminium
shaft (5). Release it before inserting the fibreglass stem and then lock it without forcing
too much as shown on the diagram 9 once it is inserted at the right length.
3. Put the 2 rubber washers on each side of the plastic end (8). To facilitate the insertion
you can wet the rubber washers. Insert the plastic end on the search head and screw the
nylon bolt through, finally adding the nylon nut.
4. Wind the cable around the shaft.
5. The electronic box (1) goes under the armrest. To fix it, insert the 2 wings of the armrest
in the slides of the electronic control unit, as indicated on the diagram above.
Disassembling
To remove the control box from the armrest, proceed as
indicated below.
1. Put your hands around the control box and press
slightly with your thumbs on the sides of the
armrest
1
.
2.
Whilst you keep pressure with your thumbs slip the
armrest down and remove the control box from the
armrest
2
.
3
