2
.
0
The
following
symbols
are
used
to
identify
important
safety
information
on
the
product
and
in
this
manual
:
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product
DANGER!
Safety hazard.
Risk of severe
injury or death.
DANGER!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
Fire hazard.
WARNING!
LED light
emission. Risk of
eye injury.
WARNING!
Burn hazard. Hot
surface. Do not
touch.
WARNING!
Wear protective
eyewear
.
WARNING!
Refer
to user
manual
.
Warning! Risk Group 3 (high risk) LED product according to EN 62471. Do not look into the beam at a distance
of less than 3 meters from the front surface of the product. Do not view the light output with optical instruments
or any device that may concentrate the beam.
This
product
is
for
professional
use
only
.
It
is
not
for
household use
.
This
product
presents
risks
of
severe
injury
or
death
due to fire and burn
hazards
,
electric
shock
and
falls
.
Read this manual before
installing
,
powering
or
servicing
the fixture
,
follow the
safety
precautions
listed
below
and
observe
all
warnings in this manual
and printed on the fixture
.
If you
have
questions
about
how
to
operate the
fixture
safely
,
please
contact
your
supplier.
PROTECTION
FROM
ELECTRIC
SHOCK
l
Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
l
Always ground (earth) the fixture electrically.
l
Use only a source of AC power that complies with local building and electrical codes and has both overload and
ground-fault (earth-fault) protection.
l
Before using the fixture, check that all power distribution equipment and cables are in perfect condition and rated for
the current requirements of all connected devices.
l
Power input and through out cables must be rated 16A minimum, have three conductors 1.5 mm² minimum
conductor size and an outer cable diameter of 5 - 15 mm . Cables must be hard usage type and heat-resistant to 90°
C minimum.
l
Use only
cable connectors to connect to power input sockets. Use only
cable connectors to
PowerCON
PowerCON
connect to power through put sockets.
l
Isolate the fixture from power immediately if the power plug or any seal, cover, cable, or other component is
damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs have been
completed.
Summary of Contents for EL 150.TW
Page 1: ...EL 150 TW USER MANUAL...
Page 2: ...Dimensions All dimensions are in millimeters 1 0 106 136 336 206...
Page 16: ......
