Xo XOCYL16SC, Manual

Page: 14 / 80

- 14 -
1. MOUNT TO THE WALL:
• The product is supplied pre-assembled. To install it, proceed as follows:
- Remove the four screws A as indicated in
Fig. 3 .
- Separate the bodywork from the frame, removing the plugs and then the screws B as
indicated in
Fig. 4 .
- Position the fixing template on the wall (taking the minimum distance from the hob
into account)
Fig. 6 .
Mark fixing holes and cut them into the material.
- Fix the 2 screws C and the screw anchors
(Fig. 6) , without tightening them completely.
- After the necessary adjustments have been made, fix the motor assembly X in place
using the 2 screws D
(Fig. 6) .
- Fix the air outlet bracket Y to the wall using the 2 screws E (Fig. 6) .
- Position the motor assembly X against the wall, make sure it is in a horizontal position
and tighten the screws C
(Fig. 6) .
- When carrying out the fixing procedures, use only screws and screw anchors which are
suited to the type of wall (e.g. reinforced concrete, plasterboard etc.).
- If the screws and screw anchors are supplied with the appliance, make sure that they
are suited to the type of wall to which the hood must be fixed.
- Remove the grille F
(Fig. 9) only if the air exhaust tube must be passed through the
inside of the air outlet bracket E (Fig. 8) .
- Connect the flexible hose C to the air outlet D, which in turn will be connected to the
air exhaust hole made previously.
- Position the bodywork A against the wall
(Fig. 7) and align it with the frame, pushing
it upwards (Fig. 10) .
- First, fix the side screws D on the bodywork in place (these are connected to the frame
underneath) as indicated in
Fig. 11 , then tighten the screws A on the lower part of the
cooker hood as indicated in Fig. 12 .
IMPORTANT - The range hood must be secured to wall studs or use drywall anchors
capable of supporting 35 lbs.