xTAG v3.0 Hardware Manual
5/8
3.3
System Reset
The system reset signal is mapped to a 1-bit port on the processor as described
below. It is used as an output to reset the target processor from the debugger
Pin
Port
Processor
X0D50
P32A1
RST_N
4
J3 and J4 connectors
The xTAG v3.0 has two additional connectors. These are reserved for future use.
5
24MHz Crystal Oscillator
The XS1-U8 is clocked at 24MHz by a crystal oscillator on the card. The processor
is clocked at 500MHz and the I/O ports at 100MHz, by an on-chip phase locked
loop (PLL).
XM006125A