XM Controls Tandem-Wire, Operation Manual

Page: 15 / 41

6.
Select the corresponding top left or top right Soft Button on the XM Controller.
7.
Move the wire to the other corner and check the Meta Tracking Laser Display to
ensure the image displays a mirror image.
8. Position the torch at a starting point.
5.2.3 Tracking Laser Calibration (Circumferential)
5.2.3.1 Adjust the Scribe Camera
In addition to the above steps, in order to do a circumferential weld, you must do the
following:
1.
Place the calibration tool in view of the camera and parallel to the groove.
2.
Press the LTS Calibration button on the Meta Display.
Left and right sides are determined by looking at the front of the weld
head.