XT2500 Product Manual
Page 72 | 92
CONFIDENTIAL AND PROPRIETARY
5.3.11. OBD Trip Start Reason (Bit Mask)
Value (Hex)
Description
0x0001
Detected Alternator On or Switched Ignition Input
0x0002
Detected GPS Movement
0x0004
Detected Vehicle Bus Traffic
0x0008
Detected Changing Vehicle Speed
0x0010
Detected Changing RPM
5.3.12. OBD Trip End Reason (Bit Mask)
Value
Description
0x00000001
Start Trip Detect Failed
0x00000002
Protocol detected, but no start trip conditions met
0x00000004
Failed to enable and configure OBD communications to a previous known protocol
0x00000008
Failed all attempts at vehicle protocol communications
0x00000010
Trip was active; failed to monitor any valid messages for x seconds or failed all requests for
mode 1, pid 0
0x00000020
Master Vehicle Speed ECU has stopped responding
0x0000040
Master RPM ECU has stopped responding
0x0000080
Three-Minute Timer expired with no changing RPM.
0x0000100
ECO mode not enabled and RPM of 0 detected
0x0000200
TPS Filed upload request
0x0000400
CAN Transport is not configured
0x0000800
J1939 No Valid Claim Address
0x0001000
CAN Transport - transmit not ready
0x0002000
CAN Send - CAN Controller not Active
0x0004000
CAN Bus Off
0x0008000
CAN Transmit Timeout
0x0010000
CAN hardware Off
0x0020000
CAN Invalid Transmit Length