5
2. PRODUCT DESCRIPTION
2.1. Configuration
2.1.1. Unpack the Droplet
The Droplet
TM
is delivered in a custom designed packing to protect the unit during transport. Refuse
parcels in damaged condition!
Use this package always to transport the Droplet
TM
.
The package contains:
?
Droplet
TM
luminaire
?
User manual
?
Droplet
TM
quick reference sheet
?
Mounting plate, including 4 Plastic feet
?
2 M3*10 counter sink screws
2.1.2. Install the Droplet
Make sure the unit is installed in an environment that complies with the prescriptions of paragraph 2.4.
Place of usage. Install the Droplet
TM
in 4 steps:
Mounting the Base Plate
Wiring the Base Plate
Addressing the Droplet
TM
Mounting the Droplet
TM
on
the Base Plate
Step
3
Step
2
Step
1
Step
4
Figure 1.: Install the Droplet
TM
in 4 steps
6
Step 1: Mounting the Base Plate
Make sure that the base plate is always equipped with the 4 plastic feet when using or installing the
Droplet
TM
.
Standing Droplet
TM
:
The Base Plate is provided with 4 holes. These holes can be used to mount the delivered plastic feet.
Click the narrow part of the foot into the hole, then push the rod into the foot and it is fixed on the Base
Plate.
Hanging Droplet
TM
:
In the centre of the Base Plate is a hole with a diameter of 10mm (0,39inch) reserved for the fixing of
hooks and clamps, for example a G-clamp.
Caution:
the Nut, O-ring or Bolt that will be turned to the inside of the Droplet
TM
should not be higher
than 10mm (0,39 inch).
Fixed installation:
There are 2 slotted holes in the base plate, 1 is reserved for the power cable(s) and the other is
reserved for the data cable(s). Before mounting the plate put the wiring for the Droplet
TM
trough the
holes.
The base plate can be fixed on a electric wall box. It is also possible to mount the base plate on wood
or other rigid materials, respecting proper and flat mounting of the base plate. Use screws with a max.
diameter of 3mm / 0.12inch and make sure the base plate is fixed well.
The Droplet
TM
may be used in virtually any direction: standing, hanging in vertical direction as fixed on
a wall, hanging horizontally.
Caution:
to guarantee the stability and durability of the unit in horizontal direction make sure that the unit
is placed with the logo’s on the base placed on the vertical axis!
Warning:
A Droplet
TM
with extension shaft may only operate hanging (max. extension length: 55cm /
21.65inch) in vertical direction or standing (max. extension length: 20cm / 7.87inch).
Step 2: Wiring the Base Plate
Power
Input
The Droplet
TM
is provided with an internal wide range power supply. It operates on a voltage range
from 100 to 240VAC at a frequency of 50 to 60Hz, no switches that need to be changed.
Consumption
The fixture has a maximum power consumption of 35 Watts.
Wiring
You need a 2 pole power cable of 0.75mm
2
to 1.5mm
2
/ 18AWG to 16AWG to provide the Droplet
TM
with power. Use always stranded wire for the power.
Warning:
Do not apply power while connecting the cables!
Connection of the 2 poles into the power connector on the Base Plate:
Fig 2: schematic top view of the Power connector block