Chapter 3:
Getting Started with the Base Targeted Reference Design
32
www.xilinx.com
ZC702 and ZVIK Getting Started Guide
UG926 (v3.0.1) February 12, 2013
TRD Demonstration Procedure
This section provides a procedure for setting up the ZC702 board or ZVIK and running the
demonstration provided with the kit.
Board Setup
1. For customers using the ZVIK, assemble the FMC module to the ZC702 base board. The
FMC module and HDMI video input are not required for either kit to run the TRD, but
ZVIK customers can run the TRD demonstration using the external video input in
addition to the built-in Test Pattern Generator if the FMC card is installed. Two sets of
standoff hardware are in the box, which can be used to secure the FMC-IMAGEON FMC
module on the ZC702 base board and support the free end of the board. Assemble the
hardware as shown in
Figure 3-3
. Use the longer standoffs, screws, and rubber feet for
the free end of the board.
2. Connect the cables as shown in
Figure 3-2
to prepare the ZC702 board to run the TRD
video demonstration.
a. Connect an LCD monitor to the HDMI out port P1 of the ZC702 board using an HDMI
cable.
b. Connect a keyboard and mouse to the USB hub, which is connected to the ZC702
board Micro-B USB connector J1 labeled
USB ULPI
through the USB Micro-B to
female A adapter. If a USB hub is not available, the mouse can be plugged directly
into the female USB connection of the USB Micro-B to female A adapter, but the user
X-Ref Target - Figure 3-2
Figure 3-2:
ZC702 Board Setup for a Video Demonstration
Keyboard and mouse
connected through USB hub
Video-In
Power
UG926_c3_02_080712
UART connector
J1
