Config - Device Configuration
SYSTEM-SETUP MENU:Config
MODE:2-Way
•
MODE - configures the mode of operation.
Mode:
Out 1
Out 2
Out 3
Out 4
Out 5
Out 6
None
Any Any Any Any Any Any
Stereo
2-Way
In1 In1 In2 In2 Any Any
Stereo 3-Way
In1
In1 In1 In2 In2 In2
The unit assigns the Input source for the corresponding outputs when the
Mode of Configuration is selected. The crossover point parameters like the
filter type, cut-off frequency and slope have to be configured manually in
the
Xover
Menu in each Output menu.
*Note: The configuration mode configures the input sources when selected.
The user can change the source afterwards if desired. It does not keep the
configuration in memory.
Copy - Copy channels
Copy Channels from the source to the target. When the Source and
Targets are both Inputs or Outputs, all audio parameters will be copied.
When one of the Source or the Target is an input while the other is an
output, only the Level, Polarity, Delay and EQ are copied.
•
SOURCE - Channel to be copied from.
O1:XXXXXX Copy
SOURCE:In1
•
TARGET - Channel to be copied to.
O1:XXXXXX Copy
TARGET:In2
DCP-3060 User's manual - Page 18
