background image

Cautions

Battery and its charging

• Charge a battery at temperature of 0C - 45C. Keep a battery dry. At a 

temperature of 20S - 60C battery is low.

• Do not immerse a battery in acidic and alkaline liquids. Avoid exposure 

to rain, keep a battery away from heat sources and do not leave it in high 

temperature and moisture.

• It is strictly forbidden to break, spoil, disassemble a battery and do actions, 

that can cause a short circuit.

• To recharge a vehicle, use a power adapter, that comes as original 

equipment. Do not leave a bike on a charger for more than 6 hours, a 

charging current does not exceed 2A.

• If over time a vehicle is not in use, please keep a battery in a dark, dry and 

cool place. Every two months, put a battery on a charger for two hours.

• Charge a battery in accordance with guidelines specified in instructions, or 

it may be an accident.

• Note the power adapter can be used to recharge a battery of only one 

type, at a certain voltage and current. It is strictly prohibited to use a power 

adapter for charging other devices.

• When charging batteries need to install it in a well-ventilated place. It is 

strictly prohibited to charge a battery in a closed room or in a room with a 

high temperature.

• During charging, first insert a battery and then connect an adapter to 

power supply. After a full charge, disconnect a power adapter from a power 

supply, and then disconnect it from a battery.

• If indicator light up green, you need time to disconnect a battery from a 

power supply. It is forbidden for a long time to leave a battery connected to 

a power supply after full recharging.

• During recharging, if indicators begin to light up in unusual way,  an odor 

appears,  or outer surface of an adapter become very hot, immediately turn 

off a battery from the power supply. You may need to repair or replace the 

device.

• Do not let outer substances to penetrate to a power adapter, do not 

immerse it in water or other liquids to prevent internal short circuit.

• Do not continuously transporting a power adapter in a vehicle. If you 

need to transport a power adapter, don`t expose it to strong shock during 

transportation.

• Do not disassemble or modify a power adapter.

Riding

• Carefully read instructions, find information about the device and review 

conditions, under which it is not recommended to use a vehicle. Do not pass 

a vehicle for people who cannot manage it.

• When traveling by bicycle, please wear a helmet safety, follow traffic rules.

• Before traveling, check an air pressure in tires of a bicycle, recommended 

pressure is 35-45 PSI.

• Speed   of a bike must not exceed 15 km / h, not recommended mode gain.

• When traveling, do not expose engine to excessive shaking and severe 

shocks, periodically lubricate spindle.

Brakes

• Before a trip, carefully check a status of brakes.

• First recommended brake is rear brake.

• Watch closely for wear of brake pads. If brake pads worns on 1/3, 

promptly replace them.

• In rainy and snowy weather we recommend to increase a braking 

distance.

Maintenance and storage of a bike

• Keep your bike in a dry place, avoid direct sunlight.

• Timely lubricate a chain.

• Regularly check all bolts and fasteners of all places, in time to tighten 

them if necessary.

Recommended twisting force: (on unit: N*cm) screws with washer - 60-80, 

screws stem 175-200, 175-250 saddle screws, bolts wheels 320-450.

• A degree of chain tension varies 2 cm. If this figure is less than 2 cm, 

please adjust a chain tightness.

Summary of Contents for QiCycle EF1









Reviews: