58
EN
EN
Clean the Mopping Module
Routine Maintenance
1. Press the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
3. Clean the mop pad with water only and leave to air dry before re-installing.
2. Pour out the water in the tank. Clean with only water and leave out to air
dry before re-installing.
4. If slow water flow occurs, or the volume is not well-distributed, clean the air
hole in the cover of the water tank.
Note:
Do not expose the tank to the sun directly.
57
Note:
• Remove the pad from the mopping module before cleaning it, and make sure
dirty water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every 3-6
months.
Clean the Main Wheel/Omnidirectional Wheel
Routine Maintenance
Clean the Main Brush
Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
Clean the Side Brush
Pull out the side brushes and use the cleaning tool to remove any hair
tangled on the brush.
Pull out the brush covers as shown in the diagram. Use the included cleaning
tool to remove any hairs tangled in the brush.
Note:
When there is hair tightly tangled in the main brush, do not pull out the
hair excessively to avoid damaging the main brush.
Note:
Use a tool such as a small screwdriver to separate axle and tire.
