HLP106D User Manual
Rev.1.2
16
3.8 Label Learning(Calibration)
Note
:
Users must carry out the calibration under those conditions below:
The first time to use the printer since installation;
The first time to use the printer since sensor cleaning;
Reuse the printer that has not been used for a long time;
Change a new type of media;
Printer cannot recognize the mark;
Huge change of operating environment;
Label Learning Method
:
1)
Manual label learning
2)
Auto label learning(See more information in<HPRT Utility Tool Manual>)
Manual Label Learning
The First Method
When printer is ready, hold down the
【
FEED
】
button until the Green Indicator flash twice and
then release the button, printer start to do the calibration; When printer do the calibration
under Continuous Media Mode, the calibration is invalidate.
NOTE: In order to save paper, you can reload the blank label which is used after the label
learning.
Auto label learning
Carry out label learning by printer utility tool. See more information in<CST Utility Tool Manual>.
