12
/
20
Installation and step
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use this product.
Mounting the Winch
1.
The mounting plate must be rated to at least the
winch
’s capacity.
2.
Align the winch perpendicular to center line of
the vehicle at the desired location, and mark the
locations of the winch base holes. Compare the
dimensions of the marked holes to Figure D.
3.
Before drilling, verify that the installation surface
has no hidden components or structural pieces
that will be damaged.
NOTE:
This winch can generate extreme forces.
Select a location that can withstand the rated capacity
without damage or weakening. Steel reinforcement
plates may be needed or a certified welder may need
to weld on additional bracing depending on the
mounting location.
4.
Drill holes appropriate for the hardware at the
marked locations.
5.
Install the winch using the hardware specified on
the specification chart.
9500lb, 10000lb, 12000lb, 125020lb and 1300
Mounting the Solenoid Assembly
1.
Place the Solenoid Box in a suitable place near
enough to the winch to allow the cables to be
routed properly.
2.
Mark the where the screw holes will be.
3.
Verify that the installation surface has no hidden
components or structural pieces that will be
damaged before drilling.
4.
Drill pilot holes for the mounting screws.
5.
Secure in place with mounting screws.
