Xerox Wide Format 510DP, Operator'S Manual

Page: 17 / 64

XEROX WIDE FORMAT 510 dp OPERATOR MANUAL 7
2. Powering on and off
This chapter describes the procedures for powering on and
powering off. It also describes the power consumption modes.
Powering on
To power on:
1. Switch the circuit breaker to the On ( I ) position. This turns on
power to the Printer.
2. Switch the printer power switch to the On ( I ) position. This
turns on the printer.
3. Switch on the Controller.
NOTE: During the warm-up cycle, the message display
provides a FUSER CALIBRATING message then a "printer is
warming up" message and decreasing fuser warm-up codes of
L9 to L0,. When the warm-up completes, the printer is on-line
and ready to print. The message display indicates, "XES
SYNERGIX 510dp IDLE."
Circuit breaker
switch
Printer power
switch
Controller
power switch