XES Synergix 8855
Controller Setup Manual for Firmware 7.0
15
Preparing the Host SCSI Port
Ultra SCSI Port (Host)
To use this port your workstation must have a SCSI interface card and
appropriate software installed and operating.
Enable Controller SCSI Port
Use the Printer_Defaults>Ports menu of the Web PMT to set a device
number compatible with your workstation and to disable the termination. By
default, the host SCSI port bus termination is enabled.
Figure 6 – Typical Web PMT, Ports Setup Page
Software Supported
•
ServeWare Version 2.42 or later.
•
VGS (in Xerox 150 Emulation Mode)
Data Formats Supported
•
Xerox 150 Emulation
•
Versatec Raw Raster
•
VDS
•
VCGL
SCSI Cable Description
The SCSI cable must not exceed a maximum length of 9.75 feet (3 meters).
