6
6-13
Imposition settings
Alignment and Offsets
The Alignment and Offsets settings are enabled when you choose Fit Height, Fit
Width, or Custom from the Scale Mode menu in Mixed Page mode. You cannot
change Alignment and Offsets settings in Fixed Page mode.
The Alignment controls allow you to specify the placement of a page within its
predefined slot on the sheet. For example, if the page has been scaled smaller than the
slot, you can align the page to the upper-left corner of the slot by clicking the
Alignment control corresponding to that position.
You can fine-tune the placement further by entering values (from –5184 to +5184
points) in the Offsets fields. Offset values are calculated in reference to the alignment
position, and reset to zero when you specify a new alignment.
Click to specify
upper-left alignment
Page is aligned in slot
Summary of Contents for Phaser EX7750
