![background image](http://html1.mh-extra.com/html/xerox/nuvera-100-roduction-systems/nuvera-100-roduction-systems_paper-manual_4177447052.webp)
Printing with tabs
Xerox Nuvera
B-2
Paper Guide
Installing the tabs guide
Instructions for installation of the tabs guides are included with the Feed Module Tab Guide kit.
They are also available at www.xerox.com (Customer Instructions: Feed Module Tab Guides -
Part # 701P42423) or on the Xerox Nuvera Customer Documentation CD.
Media Optimization for Pre-Cut Tabs
Note
Media Optimization is only available on Xerox Nuvera 200/288 Perfecting Production
Systems.
Media Optimization for pre-cut tabs is available only on the Xerox Nuvera 200/288 Perfecting
Production Systems. This mode maximizes productivity when printing mixed media jobs that
include pre-cut tab stock or full-cut tab stock with a width greater than 8.5 x 11 inches (215.9
millimeters).
The number of images on the photoreceptor during a single revolution is referred to as a pitch
mode. There are different pitch modes for different paper sizes. There is a deadcycle (no image
on the photoreceptor) during a pitch mode change, which causes reduced productivity. In a tab
job, the body pages and tab pages have different pitch modes, which causes deadcycling each
time the printer switches from one page size to the other. When pre-cut tabs media
optimization is enabled, all pages are run with a single pitch mode to prevent deadcycling.
The throughput rate when Media Optimization mode is enabled is 240 impressions per minute,
regardless of whether the job contains tab stock.
Pre-cut tabs can be printed one-sided only. Full-cut tabs can be printed on both sides, simplex or
duplex.
To enable Media Optimization mode when printing imaged tabs:
1.
Load paper according to the labels on the feed Trays (1, 2, 3, 4, 5 with 1 being on top) with
the tabs on the trail edge. If the job uses hole-punched tabs and hole-punched body stock,
make sure both stocks are loaded in the tray with the hole-punched edge leading. Use only
forward collated tabs.
2.
Program the media for the feed trays and run job 1-N, face-down.
Note
The system assumes tabs are right-edge portrait or bottom-edge landscape. If the job
is different, you may need to select
[rotate 180]
for the entire job.
3.
From the FreeFlow® Print Server user interface, select
[Printer: Media Optimization]
. The
window containing Media Optimization Switches displays.
4.
Select
[Pre-Cut Tabs]
and
[OK]
. You are now in Pre-Cut Tab mode and the job will print up
to 240 ipm, regardless of whether or not the job contains tabs.
Summary of Contents for Nuvera 100 roduction Systems
Page 30: ...Managing your paper supply Xerox Nuvera 2 12 Paper Guide...
Page 44: ...Tips by stock type Xerox Nuvera 3 14 Paper Guide...
Page 69: ......
Page 70: ......