Xerox N2125N - DocuPrint B/W Laser Printer, Service Manual

Page: 189 / 335

02/2000
4-90 DocuPrint N2125
REP 11.18
Initial Issue Repair-Adjustment
REP 11.18 Size Sensor Actuators
Parts List on PL 11.1
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Remove the printer from the 550 Sheet Feeder ( REP 11.1 ).
2. Remove any lower feeders if installed.
3. Remove the Tray from the Feeder.
4. Remove the 550 Sheet Feeder Left Cover ( REP 11.3 ).
5. Remove the Size Sensor Housing Assembly ( REP 11.17 )
NOTE: Observe orientation of switch actuators before removal.
6. Remove the four screws that secure the Size Sensor Actuators to the Size Sensor Hous-
ing (
Figure 1 ).
7. From the back side, disengage the two locking tabs that secure the Size Sensor Actuators
to the Housing Assembly and remove (
Figure 1 ).
Figure 1 Size Sensor Housing
Replacement
Refer to inset (A)
1. Position the Size Sensor Actuators below the Housing Assembly as shown.
2. Press and hold (B) to allow the actuators (C) to fall into position.
3. During reassembly ensure that locking tabs slide into position.
4. Reinstall the components in the reverse order.