Introduction
Xerox LS 3270
- 5 -
Changing the Driver
To change from PCL to FSL driver or vice versa, first of all the
rotary switch
has
to be in position T
at power on
. The current
printer driver will be indicated on a printout. The actual selection of
printer driver is then made by turning the rotary switch to position A
(PCL) or B (FSL). The new position will also be indicated on a
second printout. When the correct position is obtained, turn the
rotary switch
away
from the A, B or T positions (any other position
will do). The new driver is now active.
1.2. Xerox LS 3270 Features
The
Xerox LS 3270
protocol converter gives you the following fea-
tures:
•
IBM 3287, 3268
1
and 4214 emulations
•
Support of the SCS (LU1) and 3270 data stream (LU0 or
LU3) modes
including FMH data streams as required by
the host system.
•
All
IBM RPQs
•
Parallel output in PCL mode
•
Up to 8 user strings
of variable length can be transmit ted
to the printer from the
Xerox LS 3270
- automatically at
power on and before and after Local Copy from the host
system.
•
Automatic input sharing between Coax and Centronics
input ports.
•
Coax FSL setup via share port
•
Flash prom allowing downloading of new firmware via the
coax or the centronics port.
•
Support of ida PSS
•
Autoconfiguration (PCL only)
1
3268 = factory default
