6/98
Xerox DocuPrint N17 Service Manual
4-19
Repair/Adjustment Procedures
4.4 Paper Tray (Tray I)
4.4.1 Paper Size Sensor
Removal
1 Remove the Paper Tray.
2 Remove the Rear Cover (
3 Remove the Left Cover (
4 Remove the Front Cover Assembly (
REP 4.2.4 Front Cover Assembly).
5 Remove the Paper Handling Unit Assembly (
REP 4.5.1 Paper Handling Unit Assembly).
6 Remove the System Controller Chassis (
REP 4.12.1 System Controller Chassis).
7 Disconnect the Paper Size Sensor connector (P/J 135). (See Figure 4.4.1.1.)
8 Press the round clip and the Paper Size Sensor Assembly Stop from the System Controller side
to the paper tray side; then slide the Paper Size Sensor towards the front and remove it.
Figure 4.4.1.1 Paper Size Sensor Removal
Replacement
Perform the removal steps in reverse order.
SAS413F.CDR
P/J135
SAS414FA
www.printcopy.info
www.printcopy.info