7/99
Repair Analysis Procedures (RAPs)
7-86
Xerox DocuPrint N17 Service Manual
Skew
Observe the Printer Engine Controller test pattern. Measure the dimensions ‘A’ and ‘B’ on two
consecutive test patterns and check the following, Figure 7.5.3.8. The difference between ‘A’ and
‘B’ should be no more than 1.5 mm from any source.
The skew on the test patterns meets the specification.
Y: The printed test patterns meet the Skew specification. Go to the Skips and Smears
checkout on the next page.
N: Go to
Figure 7.5.3.8 Print Engine Controller Test Pattern
Direction of Paper Travel
B
•
190mm
A
www.printcopy.info
www.printcopy.info