SETTING THE SYSTEM CONFIGURATION
XEROX DOCUPRINT 92C IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
4-61
Specifying stitching attributes
(for systems with a stitcher)
To specify stitching attributes, follow these steps:
1. On the Output Configuration window, check the “Stitching” box,
then click the Stitching Attributes button. The Stitching
Attributes window displays.
Figure 4-46. Stitching Attributes window
2. On the Stitching Attributes window, make selections or enter
values in the fields described below.
•
Set Sheet Delivery — Specifies whether sheets will be
delivered Face Up or Face Down.
•
Page Order within Set — Specifies the order in which
pages in a set will be delivered to the output bin: first-to-last
or last-to-first.
—
1 to N — Output sheets are delivered to the output bin
in ascending order (the first page is delivered first).
—
N to 1 — Output sheets are delivered to the output bin
in descending order (the last page is delivered first).
Note:
The size of the ordered set must fall within the
specified maximum set size.
•
End of Set Criteria — Specifies the criterion that marks the
end of a set for your system.
—
Offset Stacker — A JOG (offset) command in the job
indicates the end of a set.
—
MarkForm — A MARKFORM command in the job
indicates the end of a set.
•
Maximum Set Size — Specifies the maximum number of
sheets that can be in a set. The range for DFA sets is 10 to
50.
Summary of Contents for DocuPrint 92C IPS
Page 8: ...TABLE OF CONTENTS viii XEROX DOCUPRINT 92C IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM...
Page 12: ...INTRODUCTION xii XEROX DOCUPRINT 92C IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM...
Page 132: ...INDEX INDEX 6 XEROX DOCUPRINT 92C IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM...
