Xerox document centre285 series, User Manual

Page: 63 / 209

Useful Operations
51
3
3.5
Outputting
This section explains the two types of outputting:
●
Forced outputting of remaining print data
● Outputting all jobs in the printer
3.5.1 Forced outputting of remaining print data
For the PCL emulation mode, data will not be output until a full page of data is collected.
If the last piece of data ends at the middle of a page, it will wait for the next data until the
present Auto Eject Time has passed and "Data wait" will be shown on the display.
To forcibly print data in the printer without waiting for the Auto Eject Time to pass in such an
instance is known as forced outputting.
The procedure is as follows:
For parallel interface, the next job sent when the display shows "Data wait" might not be printed properly.
Send the next job after forced outputting or when Auto Eject Time is over.
"5.3 Common Menu Items" regarding Auto Eject Time.
Procedure
When the display is at the state as shown on the
left, press .
Printing will begin.
When printing is done, "Ready to print" will be
shown.