Xerox Scanner User’s Guide
12
Installation
Connect the USB Cable and Turn on the Power
Your scanner connects to any available USB port. Check your computer’s
manual for USB port locations.
1.
Remove any protective tape from the USB cable.
2.
Plug the USB cable into the USB port on the scanner then into a USB
port on the computer.
3.
Turn on the power switch, located on the back of the scanner to the
left of the power port.
The status light comes on and flashes indicating that the scanner is
receiving power.
If you are using Windows XP and have plugged the USB cable into a
USB 1.1 port, an information bubble may open explaining that “A HI-
SPEED USB device is plugged into a non-HI-SPEED USB hub”. Plug
the USB cable into a USB 2.0 port (if available) or just disregard the
message. If you leave it plugged into the USB 1.1 port, your scanner
may scan a bit slower.
Your computer then recognizes that a scanner has been plugged into
the USB port and automatically loads the appropriate software to run
the scanner.
If your computer is running Windows XP or Windows Vista, you will
see a message similar to the following.
4.
When you’re certain that the software has completely loaded, return
to the “Complete the installation by connecting your hardware”
window.
USB Symbol
Summary of Contents for DocuMate 752
Page 1: ...DocuMate 752 user s guide scanner...
Page 70: ...VC 000...
