22
Set IPSec Address
1.
Enter the IP Address in the [Specify Destination IPv4 Address] box on the [IPSec] screen.
2.
Enter the IP Address in the [Specify Destination Ipv6 Address] box.
3.
Select [Enabled] or [Disabled] from the [Communicate with Non-IPSec Device] dropdown list.
4.
Click the [Apply] .
5.
Click the [Reboot Machine] .
Note:
When you select [Enabled] for [Communicate with Non-IPSec Device] setting, the machine allows
communications with non-IPSec devices other than specified for [Specify Destination IPv4 Address] or [Specify
Destination IPv6 Address].
Set SNMPv3
1.
Click [Connectivity] on the [Properties] screen.
2.
Click [Protocols].
3.
Click [SNMP Configuration].
4.
Check the [Enable SNMPv3 Protocol] box.
5.
Uncheck the [Enable SNMP v1/v2c Protocols] box.
6.
Click the [Apply] .
7.
Click the [Edit SNMPv3 Properties] and check the [Account Enabled] for [Administrator Account].
8.
Enter a new Authentication Password (minimum 8 characters ).
9.
Enter the Confirm Authentication Password.
10.
Enter a new Privacy Password (minimum 8 characters ).
11.
Enter the Confirm Privacy Password.
12.
Check the [Account Enabled] for [Print Drivers/Remote Clients Account].
13.
Click the [Apply] .
Note:
Authentication Password and Privacy Password have to be changed certainly from default Password.
In using SNMPv3, use the IPSec protocol simultaneously. Therefore the IP address of the client for SNMPv3 have to
be set according to the procedures "Set IPSec Address", Enter the IP Address in the [Specify Destination IPv4/IPv6
Address] box.
Since the machine cannot communicate by SNMP v1/v2, the port setting on the client Printer Driver have to be
unchecked the [SNMP status Enabled].