Xerox Copycentre C118, System Administration Manual

Page: 87 / 134

IPP Installation
Xerox CopyCentre/WorkCentre 118 System Administration Guide 87
Network Communication Setup
This section describes how to set up the network communication parameters of the
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
NOTE: CentreWare Internet Services can also be used to configure the machine.
Refer to the CentreWare Internet Services chapter.
Initially, enable the IPP port.
1.
Connect the machine to the network.
2.
Press the <Log In/Out> button.
3.
Select [System Settings].
4.
Enter the password using the numeric keypad and then select [Confirm].
5.
Select [Print Settings] and then press the <Enter> button.
6.
Press the <Enter> button on the [Network/Port] screen.
7.
Select [IPP] by selecting [
T
] or [
S
] and then press the <Enter> button.
8.
Select [Port Status] by selecting [
T
] or [
S
] and then press the <Enter> button.
9.
Select [Enable] by selecting [
T
] or [
S
] and then press the <Enter> button.
If necessary, you may change the following settings.
• Print Mode
• PJL
• Access Control
• DNS
• ADD Port No.
• Connect Time-Out
• TBCP Filter
Next, establish TCP/IP.
1.
Press the <Exit> button once or twice to display the [Network/Port] screen.
2.
Select [TCP/IP Settings] by selecting [
T
] or [
S
] and then press the <Enter>
button.
3.
Select [Get IP Address] by selecting [
T
] or [
S
] and then press the <Enter>
button.
4.
Select [DHCP/Autonet], [DHCP], [BOOTP], [RARP], or [Manual] by selecting [
T
]
or [
S
] and then press the <Enter> button.