Xerox 3210 - workcentre b/w laser, Service Manual

Page: 19 / 416

WorkCentre 3210/3220 Color Laser Printer Service Manual xvii
In the event of a problem you should contact your authorized local dealer in
the first instance.
This product has been tested to and is compliant with TBR21, a specification
for terminal equipment for use on analogue-switched telephone networks in
the European Economic Area. This product provides an user-adjustable
setting of the country code. Refer to the customer documentation for this
procedure. Country codes should be set prior to connecting this product to the
network.
Note
Although this product can use either loop disconnect (pulse) or DTMF
(tone) signaling, it is recommended that it is set to use DTMF signaling.
DTMF signaling provides reliable and faster call setup. Modification of this
product, connection to external control software or to external control
apparatus not authorized by Xerox, will invalidate its certification.
New Zealand Telecom Warning Notice
1. The grant of a Telepermit for any item of terminal equipment indicates
only that Telecom has accepted that the item complies with minimum
conditions for connection to its network. It indicates no endorsement of
the product by Telecom, nor does it provide any sort of warranty. Above
all, it provides no assurance that any item will work correctly in all
respects with another item of Telepermitted equipment of a different make
or model, nor does it imply that any product is compatible with all of
Telecom’s network services.
The equipment may not be capable of correct operation at the higher data
speeds designated. 33.6 kbps and 56 kbps connections are likely to be
restricted to lower bit rates when connected to some PSTN
implementations. Telecom will accept no responsibility should difficulties
arise in such circumstances.
2. Immediately disconnect this equipment should it become physical
damaged, and arrange for its disposal or repair.
3. This modem shall not be used in any manner which could constitute a
nuisance to other Telecom customers.
4. This device is equipped with pulse dialing, while the Telecom standard is
DTMF tone dialing. There is no guarantee that Telecom lines will always
continue to support pulse dialing.
5. Use of pulse dialing, when this equipment is connected to the same line
other equipment, may give rise to ‘bell tinkle’ or noise and may also cause
a false answer condition. Should such problems occur, the user should
NOT contact the Telecom Fault Service.
6. The preferred method of dialing is to use DTMF tones, as this is faster
than pulse (decadic) dialing and is readily available on almost all New
Zealand telephone exchanges.
7. Warning Notice: No ‘111’ or other calls can be made from this device
during a main power failure.
8. This equipment may not provide for the effective hand-over of a call to
another device connected to the same line.