dc99cc0135
Page 8
Document Centre Technical Support Operations
Section IV - Driver Accessibility through PageMaker 6.5
and QuarkXpress
Accessing the Custom Driver through PageMaker
Do the following steps to access the DC 265/255/240 or 490/460 custom Macintosh driver
interface in Macintosh PageMaker 6.5.
NOTE:
Follow these steps if you use the Xerox DC 265/255/240 or 490/460 Document
Centre custom Macintosh drivers with the custom PPDs. Do not follow this procedure if you
are using the Adobe PostScript driver or the LaserWriter driver with the generic PPDs.
1. In PageMaker, press the Option key and select [
File: Print
].
2. Select [
Setup
].
3. Select <
OK
>. This opens the Xerox driver interface.
4. In the pulldown menu, select [
Xerox Options
].The Xerox custom interface appears.
5. Select [
Extended Options
] to enable Document Centre options such as secure print,
sample set, banner sheet toggle on/off, and cover selections.
Paper Trays Cannot be Selected from PageMaker with Generic Driver
(LaserWriter or Adobe) and Xerox Generic PPDs
Problem:
PageMaker does not pull the configuration information from the setup in the Chooser for the
DC 265/255/240 or 490/460. You must configure the device options from within the
application as well as in the Chooser.
Solution:
To configure the driver (LaserWriter, Adobe driver), do the following steps:
1. In the Chooser select the LaserWriter or Adobe printer driver.
2. Select
[
Setup
], [
Select PPD
] and select the generic or generic for DocuTech PPD for
your Document Centre system.
3. Select
[
Configure
].
4. Select
[
Install
] for the appropriate features (Finisher or Tray 6) for your Document
Centre.
5. Open PageMaker and verify that the Page Setup has the appropriate paper size
selected.
6. Select
[
File: Print
].
7. Ensure that one of the generic PPDs or generic for DocuTech PPD’s is selected.
8. Select
[
Features
] to configure the appropriate features for your Document Centre.
NOTE:
The features are listed in a scrolling menu. The Finisher and Tray 6 options are at
the bottom of the list.
9. Select
[
Paper
].
10. Select the paper size and the corresponding tray. You are now ready to print.
