Xentino SR2 Series, User Manual

Page: 54 / 67

SR2XX SERIES 2W/4W/8W G.SHDSL (BIS) EFM ROUTER UM V.0.7
– WWW.XENTINO.COM 54
SNMP
Simple Network Management Protocol (SNMP) defines the exchange of messages between a
network management client and a network management agent for remote management of network
nodes. These messages contain requests to get and set variables that exist in network nodes in
order to obtain statistics, set configuration parameters, and monitor network events. SNMP
communications can occur over LAN or WAN connection.
The router can generate SNMP traps to indicate alarm conditions, and it relies on SNMP community
strings to implement SNMP security. The SHDSL.bis routers support SNMPv1/SNMPv2 (RFC
1157/1901/1905) and MIB-II (RFC 1213/1493)
Click SNMP to configure the parameters for remote management via SNMP.
SNMP
Item Description
Port Enter port number for the SNMP service
Access Status Click on the drop-down list and select ALL to allow the service or Disable
WAN to disable the remote management service
SNMP Configuration
Item Description
Get Community Enter the password for the incoming Get and Get Next requests from the
management station. The default is public which allows all requests.
Set Community Enter the password for the incoming Set requests from the management
station. The default is public which allows all requests.
Trap Community Enter the password sent with each trap to the SNMP manager. The default
is public which allows all requests.
Trap Destination Enter the IP address of the station to send SNMP traps
Click on Apply to save the parameters or Cancel to start configuring this page from beginning.
WWW
Click WWW to configure the parameters for remote management via WWW.
WWW
Item Description