Xenotech BRITELIGHT 7000, Operating Manual

Page: 7 / 38

PAGE 7
DISASSEMBLY PROCEDURE
IF THERE IS NO XENON BULB INSTALLED IN THE FIXTURE
1. Remove the (8) screws located on the small sides of the front cowling using a #2 phillips screwdriver and
remove the cowling.
2. Remove the (2) brass bolts connecting the short leads to the front lamp holder using a 7/16" wrench..
3. Remove the center mounting screw washer and spring from the spider using a 5/32" allen wrench while
supporting the front lamp holder so that it does not fall when the screw is removed.
4. Remove the lamp holder from the fixture.
5. Disconnect the focus rod swivel joint from the spider arm using the 5/16" and 3/8" open end wrenches. Do not
turn the swivel joint or focus rod.
6. To disassemble the front lamp holder remove the (2) clamp retaining screws located on the side of the lamp
swivel hub using a 5/32" allen wrench and remove the clamp.