Xenotech BRITELIGHT 7000, Operating Manual

Page: 6 / 38

PAGE 6
INSTRUCTIONS FOR REMOVING AND INSTALLING A TYPE TH BULB IN A BL7000
FIXTURE
NOTE
FAMILIARIZE YOURSELF WITH THE LOCATION AND IDENTIFICATION OF THE COMPONENTS OF THIS
SYSTEM AND ALSO THE NORMAL OPERATION OF THE SYSTEM BEFORE ATTEMPTING ANY
ADJUSTMENT OR SERVICE.
NOTE
COMPLETELY READ THROUGH AND HAVE A GOOD UNDERSTANDING OF THE PROCEDURES BEFORE
ATTEMPTING TO SERVICE THIS SYSTEM. FAILURE TO DO SO MAY RESULT IN FATAL INJURY OR
EQUIPMENT DAMAGE.
WARNING
DISCONNECT POWER SOURCE BEFORE SERVICING THIS EQUIPMENT.
WARNING
A PROTECTIVE JACKET, FULL FACE SHIELD, AND PROTECTIVE GLOVES MUST BE WORN AT ALL
TIMES WHEN THE LAMP HEAD IS OPENED WITH A BULB INSTALLED OR WHEN HANDLING THE XENON
BULBS. SERIOUS INJURY MAY OCCUR IF PROPER SAFETY PRECAUTIONS ARE NOT OBSERVED. READ
ALL ENCLOSED INSTRUCTIONS AND INFORMATION SHEETS BEFORE HANDLING THE BULB.
WARNING
NEVER OPERATE A FIXTURE WITH AN EXPOSED BULB! THERE IS AN EXTREME DANGER OF SEVERE
BURNS TO EXPOSED SKIN AND EYES FROM THE ULTRAVIOLET LIGHT EMITTED FROM THE EXPOSED
BULB. DAMAGE CAN OCCUR IN AS LITTLE AS 30 SECONDS OF EXPOSURE. THERE IS ALSO AN
ADDITIONAL DANGER FROM FLYING QUARTZ IF AN EXPOSED BULB EXPLODES!
EQUIPMENT REQUIRED
1. PROTECTIVE SAFETY EQUIPMENT KIT
2. 7/16", 5/16", 3/8" OPEN END WRENCH
3. ALLEN WRENCH 5/32"
4. PHILLIPS SCREWDRIVER #2