Xenotech BL7000, Operating Manual

Page: 35 / 38

PAGE 35
Manual Operational Mode
The manual operation will allow the fixture to be used in a conventional manner where power to the
fixture is manually switched ON for “stand alone” use. This is done by pressing the power switch/ circuit
breaker on the xenon power supply to the ON position.
1. Plug the power cord into a power source and push the power switch/ circuit breaker to the ON
position.
2. The display will energize and show the TIMER mode - select ADDRESS mode by depressing the
FUNCTION SELECTION BUTTON (diamond). The display should read
FOCS or GOB1.
3. The fixture displays are initially preset at the factory to the address
“FOCS” or "GOB1" when it
arrives. If this address is not displayed, press the NUMERIC SELECTION BUTTONS (triangles) until the
display reads
“FOCS” or "GOB1."
4. Press the Numeric Selection Buttons indicated below to perform MANUAL functions.
NOTE: The NUMERIC SELECTION BUTTONS scroll with ascending numbers, from “0” to “9” before recy-
cling to “0.”
Function Selection Button Display Window
Numeric Selection Buttons
Left Display Window for Manual Mode
FUNCTION DISPLAY & RELATED BUTTONS
The P3 has (2) displays on the rear panel; the left display for ON/OFF and the right display for Gobo
Selection. The displays and related buttons serve to track lamp life in hours and perform DMX func-
tions. Whenever the fixture is turned ON, the display will remain active for approximately 5 minutes. This
time will extend to approximately 5 minutes after the
last function or selection input is made to the
fixture (after it first turned ON) and additional control interfacing is necessary. After approximately 5
minutes, the display will extinguish and remain in a “sleep” mode. The fixture will remain like this until the
selection button is depressed once. If it is necessary to see the displays (read lamp hours or to change
the fixture address), press the FUNCTION SELECTION BUTTON and the display will reactivate. After the
initial 5 minutes the fixture is ON, the displays will remain active for 30 seconds
after the last function or
selection button is depressed before returning to the “sleep” mode.
100's Lamp ON/OFF (toggle)
10's Gobo CLOCKWISE
1's Gobo COUNTERCLOCKWISE
100's 10's 1's
Right Display Window for Manual Mode
100's 10's 1's
Press "1's" button to select another
gobo. Illustration shows "Gobo 1"
selected; pressing "1's" button once
will select "Gobo 2."