06
Controls Configuration
A1
E
G
J
L
N
P
V
A
B
C
D
H
I
K
M
O
F
S
T
U
Q
R
I)
Control Stick
Mode 1: Throttle and Aileron
Mode 2: Throttle and Rudder
J) Control Stick
Mode 1: Elevator and Rudder
Mode 2: Aileron and Elevator
K) Trim Switch
L) Trim Switch
M) Trim Switch
N) Trim Switch
O) On/Off Switch
P) Clasp for Shoulder Strap
Q) MENU Key
1) Enter Main Menu
2) Change Menu
R) SUB Key
1) Enter Submenus
2) Change Submenu
S) Y/UP Key
1) Confirm Selection
2) Increase Selected Data
T) RIGHT Key, Next Selection Right
U) N/DOWN Key
1) Cancel Selection
2) Decrease Selected Data
V) LEFT Key, Next Selection Left
W) Handle
X) Bind Button
Y) Simulator Socket
Z) Battery Compartment
A1)Charging Socket
A) Antenna
B) LCD Display
The following values are shown:
1) Battery Voltage
2) Channel Reversal
3) Duration of Flight
4) Throttle Lock
C) Autorotation Switch
D) Switch for Ch. 5 (Gyro/Landing Gear)
E) Switch for 3D Mode
F) Dual Rate Switch
G) Green Control LED:
Glows as soon as the transmitter is
switched on.
H) Red Control LED:
If the transmitter is switched on in the 3D
mode and/or the throttle/pitch stick is
not in its lowest position, the LED will
glow constantly red. To use the
transmitter, switch off the 3D mode
and/or bring the throttle/pitch stick in its
lowest position. The red LED will then go
out.
As soon as the battery voltage drops
below 8.5 V, the red LED will start to
blink.
WARNING: Replace the batteries
immediately!
X
W
Z
Y
www.xelaris.ch
