FPV-Set 5.8 GHz Rocket 400 GPS
EN
6
FPV-Set 5.8 GHz Rocket 400 GPS
Install the monitor bracket at the transmitter as shown in the
fi gure. Fix the monitor with the large screw on the bracket
(see circle).
Finally screw the antennas to the monitor.
Getting Started Guide FPV-Set Rocket 400 GPS
WARNING:
For legal reasons, a line of sight between the pilot and Quadrocopter must always exist to
recognize a dangerous situation or loss of video signal in time and be able to react immediately. Therefore
never fl y in blind areas in which you rely only to the camera view -
crash hazard!
1. Installation of the 5.8 GHz transmitter at the Rocket 400 GPS
Secure the transmitter with double sided tape on the
underside of the Quadrocopter as shown in the picture.
Screw on antenna fi rmly.
Connect the included cable to the transmitter and the Qua-
drocopters plugs.
WARNING:
Observe polarity -
heat
generation and fi re hazard!
Insert the MicroUSB connector of the cable into the AV so-
cket on the camera.
Note:
when the camera is not used,
switch the camera off and unplug the AV cable.
Switch on the camera before you start.
Note:
activate the
TV-Out option in the camera menu - see chapter operation.
+
-
2-pole connector
-
