17
XciteRC Flybar 400E Easy
EN
Battery charging
·
Getting started
·
RC functions
Charging wire
Mains charger
Balancer connector
Battery charging
WARNING:
Be sure to read all safety instructions regarding
the use of rechargeable batteries. Charging may take place only with
the supplied charger on a fireproof surface and under constant adult
supervision -
fire or explosion hazard!
• Connect the charger to a suitable 230 V AC outlet. The green
LED lits.
• Connect the charging wire with the helicopters balancer connec-
tor.
•
WARNING:
The balancer connector is polarized. Check the
side channels. Do not use force -
fire or explosion hazard!
• The LED color changes to green to indicate charging. Charging
time is about 120 minutes. If the battery is fully charged, the LED chnages back to green.
• Unplug the battery and the USB cable.
The flight time of the helicopter is about 6-8 minutes.
Getting started
Before you begin please check:
•
WARNING:
Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery –
crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Connect the battery with the helicopter.
WARNING:
The battery connector is polarized. Check the
side channels. Do not use force -
fire or explosion hazard!
• Switch on the helicopter with the switch at the left side - switch in the ON position. Place the helicopter
on a flat surface in the starting position.
• Then switch on the transmitter. The POWER LED flashes.
• After a few seconds, the POWER LED of the transmitter goes off - the helicopter is now ready for flight.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a
suitable place to land safely. Charge the flight battery again.
RC functions
Up - down
Move the throttle lever forward, the motor revs
up and the helicopter rises. Move the throttle
lever backwards to sink again.
Trim up - down
If the rotor turns, even when the throttle lever
is fully down, keep pressing the trim button
down until it stops. If it will not turn, even when
you give gas, trim upwards.
Forward - reverse
Move the direction lever towards you, the
helicopter will move forward. Move the throttle
stick back to reverse.
Trim forward - reverse
When hoovering, the helicopter must stand in
place. If it moves forward, move the trim
button down until it stops, or vice versa.
Left - Right (yaw)
Move the direction lever to the left, the
helicopter turns to the left. Move it to the right
to turn the helicopter to the right.
Trim left - right
When hoovering, the helicopter must stand in
place. If it moves to the right, move the trim
button to the left until it stops, or vice versa.
Left - Right (roll)
Move the direction lever to the left, the
helicopter turns to the left. Move it to the right
to turn the helicopter to the right.
Trim left - right
When hoovering, the helicopter must stand in
place. If it moves to the right, move the trim
button to the left until it stops, or vice versa.
Summary of Contents for Flybar400 Easy
Page 33: ...33 XciteRC Flybar 400E Easy ...
Page 34: ...34 XciteRC Flybar 400E Easy ...
Page 35: ...35 XciteRC Flybar 400E Easy ...
