XciteRC 15004000, Manual

Page: 26 / 48

26 XciteRC Dragon 250
EN
Landing
·
Maintenance
·
Trouble shooting
little less throttle.
Landing:
• Carefully push the left throttle lever rearward. Try to land „smooth“ without damaging the Race-Copter.
• Lock the motors: Move the right stick to the lowest right position and hold it for about 3 seconds.
• Disconnect flight battery in the model, and then turn off the transmitter.
• Remove the battery from the model and store with the correct storage voltage (approximately 11.5 V).
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
Maintenance
To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately –
fire hazard!
Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
Troubleshooting
Problem Solution
Motors won’t start Unlock the motors, see chapter Getting started
Battery voltage low, recharge or exchange battery
Quadcopter not bound to the transmitter, see chapter Binding
Model doesn’t take off Check the assembly of the propellers – rotational direction
The quadcopter does not react
to the transmitter Transmitter battery voltage low, recharge or change battery
Quadcopter not bound to the transmitter, see chapter Binding