XciteRC 12005000, Manual

Page: 17 / 36

17
XciteRC Flybar 180S Coax
EN
Battery charging
·
Getting started
Battery charging
WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
Charging via transmitter
• Turn on the transmitter.
• Open the compartment on the back side of the transmitter. Connect the helicopter to the adapter. The
helicopter must be switched off!
• WARNING:
The battery connector is polarized. Check the side channels. Do not use force -
fire or
explosion hazard!
• The green LED of the transmitter starts to light red solid and displays the charging process. Charging time
is about 50-60 minutes. If the battery is fully charged, the red LED turns off.
• If the red POWER LED flashes, the transmitter batteries need to be changed.
Charging via USB port
• Insert the USB plug into a suitable socket on your PC or notebook (or power adapter with USB socket).
The red LED lits. Connect the helicopter to the adapter. The helicopter must be switched off!
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire or
explosion hazard!
• The red LED goes out and displays the charging process. Charging time is about 50-60 minutes. If the
battery is fully charged, the red LED turns to on.
USB
The flight time of the helicopter is about 6-8 minutes.
Getting started
Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery –
crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Switch on the transmitter. The POWER LED flashes.
• Then switch on the model. The red LED on the receiver board starts to flash.
Place the helicopter in the start position and move the left throttle lever all the
way up and then back in the lowest position. This safety circuit prevents the rotor
may start after turning ON the helicopter
• The transmitter LED and the red helicopter LED will now light.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a
suitable place to land safely. Charge the flight battery again.
ON
OFF