![XciteRC 12005000 Manual Download Page 16](http://html.mh-extra.com/html/xciterc/12005000/12005000_manual_882100016.webp)
16
XciteRC Flybar 180S Coax
EN
The remote control system
The remote control system
Here you get an overview of the remote control system of your XciteRC Flybar 180S and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter. Remove the screw and
open the cover (1). Insert six AA batteries into the battery compartment of the transmitter (2). Pay attention
to the correct polarity!
Battery Cover
6x 1.5 V AA
Batterien
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• When the POWER LED is flashing, move the left throttle lever to the top position, then back to the bottom.
The POWER LED will light constantly. This safety circuit prevents the rotor may start after turning on the
helicopter.
• The POWER LED must lit.
Attention:
if the POWER LED flashes or does not light at all, the model may
not started –
crash hazard!
Change transmitter batteries immediately.
•
WARNING:
check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries –
crash hazard!
•
ATTENTION:
The maximum range of the remote control system is about 10 meters, do not fly
farther away under any circumstances! If the XciteRC Flybar 180S gets out of range, the fail-safe function
is activated and turns off the motor.
Transmitter
Throttle
lever
Direction
lever
POWER-LED
IR-Transmitter
ON/OFF-Switch
Trim
Charging
connector
(backside)
Channel select
ATTENTION:
The
IR-Transmitter must always
point toward the helicopter -
crash hazard!
The helicopter can be ope-
rated with two different
channels (A-B) - important
when two pilots wants to fly
together. Select the channel
on the transmitter, switch on
the heli, when the LED on
the helicopters PCB start to
lit you can start.
Summary of Contents for 12005000
