background image

Page 2 of 4

1

3

2

4

Product Name: 

       +44(0)1952 292441
       [email protected]
Document No: 

V1

Tamlite Technical
Stafford Park 12, 
Telford, Shropshire, 
TF3 3BJ

INSTALLATION & OPERATING INSTRUCTIONS

IP67

220-240V

50/60Hz

ta

-25°C to 40°

Can cause serious 

eye damage. In case 

of contact with eyes, 

irrigate with water & 

seek medical advice.

Use it in well 

ventilated area 

only. Spillage 

must be cleaned 

immediately.

No naked flames. 

Keep out of reach of 

children

WARNING!

IP20

IP67

!

Important information

Remove the product from its packaging.

Measure the length of the strip required for the installation.

The strip can be cut to length at 50mm intervals at the indicated position.

Remove the foil seal from the silicone glue tube and install the nozzle.

PLEASE NOTE: The strip in this kit is rated at IP67 but the controller and driver are rated at IP20. IP20 components must be installed in a dry location.

Summary of Contents for XCPSK67RGB

Page 1: ...t perform insulation strength or insulation resistance tests on the installation with the luminaire s connected this can damage the luminaires and give erroneous readings Do not loop in supply cables at the luminaire supply terminals unless there is provision for 2 way connection at the terminals The light source contained in this luminaire must only be replaced by Tamlite Lighting or an appointed...

Page 2: ...ntilated area only Spillage must be cleaned immediately No naked flames Keep out of reach of children WARNING IP20 IP67 Important information Remove the product from its packaging Measure the length of the strip required for the installation The strip can be cut to length at 50mm intervals at the indicated position Remove the foil seal from the silicone glue tube and install the nozzle PLEASE NOTE...

Page 3: ...ting surface Connect the controller to the power supply lead Connect the controller to the lead and observe Triangle to Triangle Remove the terminal covers from the LED driver Apply silicone glue in to the silicone end cap and cut end of the strip kit Insert the strip in to the end cap and ensure good seal with the silicone glue Continue to install the strip ensuring good contact with the mounting...

Page 4: ...ed button i e Blue button for Blue light Brightness control To change the brightness of the light press the button to increase or the button to decrease the intensity Dynamic mode The dynamic option can be switched on by pressing the FLASH STROBE SMOOTH or FADE button The colours will automatically change in a programmed tempo To switch off the dynamic mode press any colour button IP67 13 14 16 15...

Reviews: