Xcel-Arc RAZORWELD MIG200, Operating Manual

Page: 12 / 40

12 12
Installation set up for MIG with Gas for XA-MIG200RZ
(1) Select the MIG function with the Tig/MMA/Mig selector switch.
(2) Select Standard using the Standard/Spool Gun selector switch.
(3) Plug the welding torch into the Euro Mig torch connection socket on the front panel, and tighten it.
IMPORTANT :
When connecting the torch be sure to tighten the connection. A loose connection can
result in the connector arcing and damaging the machine and gun connector.
This damage is not covered under warranty.
(4) Insert the earth cable plug into the negative socket on the front of the machine and tighten it.
(5) Connect Gas Line to Gas Regulator and connect the gas regulator to the Gas Cylinder.
(6) Connect the weld power cable plug inside the wire feeder to the output socket GAS, and tighten it.
(7) Place the Wire Spool onto the Spool Holder - Note: the spool retaining nut is Left Hand thread.
Snip the wire from the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into
the wire feeder inlet guide tube through to the drive roller.
(8) Carefully feed the wire over the drive roller into the outlet guide tube, feed through about 150mm into
the torch receptacle. Check that the drive roller being used complies with the wire diameter, replace the
roller if necessary.
Caution:
Disconnect the Electrode Holder cable from the machine before using MIG function. If cable is not disconnected welding
voltage is present and can cause arcing or

ash.
(7) Place wire onto spool holder - (spool retaining
nut is left hand thread ) Feed the wire through the
inlet guide tube on to the drive roller.
(6) Connect weld power lead to
(8) Feed wire over the drive roller into
the outlet guide tube, Push the wire
through approx 150mm.
(4) Connect earth
lead
to
(2) Set Standard/Spoolgun
selector switch inside door
to Standard
(5) Connect the gas line to the regulator
and connect to the gas cylinder
(1) Set Tig/MMA/Mig selector
switch to Mig
IMPORTANT :
When connecting the torch
be sure to tighten the connection.
(3) Connect Mig torch