![background image](http://html.mh-extra.com/html/xantrex/rs3000/rs3000_installation-manual_881442050.webp)
Installation
34
975-0171-01-01
Step 6: Connecting to the Network
For your reference, Figure 13 shows where the network connections are made on
the RS3000.
To connect the RS3000 to the Xanbus network:
u
Plug a network cable connected to the Xanbus network into either one of the
two network jacks on the RS3000.
Detailed information on planning and installing your network is available in the
Xanbus System Installation Guide.
Refer to the this guide to determine the type of
network layout to install, as well as guidelines for installing the network.
The Xanbus System Installation Guide is available for download at
www. xantrex.com
CAUTION: Equipment damage
Connect the RS3000 only to other Xanbus compatible devices.
Although the cabling and connectors used in this network system are the same as Ethernet
connectors,
this network is not an Ethernet system
. Equipment damage may result from
attempting to connect two different systems.
Figure 13
Connecting to a Network Jack
Summary of Contents for RS3000
