Installation
6
975-0264-01-01 Rev A
Figure 4
Connecting the RC8 to the Inverter
+12V
Connect the Communications
Cable to the inverter at the
COM Port
or
RC8 Remote Port
.
Note:
The location of the COM port or
the RC8 Remote Port may vary
depending on the model of inverter
used.
RJ11 Plug on
Communications
Cable
12 Vdc Fuse
Ignition Switch
12 Vdc Wire
Jumper Pin
AUX INPUT
+12 Vdc
Communications Cable
(10, 25, 50, or 100 ft.)
RJ11 Port on the
Back of the RC8
Plastic Standoffs
Plastic Standoffs
975-0264-01-01 Rev A
7
3
Operation
Chapter 3, “Operation” describes the operation of the RC8
Remote Control.
Startup and Test
To Start up and Test the RC8 Remote Control:
1. Switch the inverter ON using the inverter’s front panel
ON/OFF switch.
2. Verify the POWER LED is ON (both inverter and
remote).
3. Press the ON/OFF switch on the RC8 to turn the inverter
OFF. Press it again to restore power.
Operation
The RC8 Remote Control operates as described in the
following sections depending on which inverter is connected
to it.
Summary of Contents for RC8
Page 2: ......
