Xantrex PH1800-GFP, Installation Manual

Page: 44 / 76

Installation
3–4 975-0289-01-01
Preparing the Battery Bank
Figure 3-3 Preparing the Battery Bank
1. Insert the batteries into the
compartment.
2. Connect the batteries as
shown below depending on the
battery configuration used.
3. Tighten the Hex nut on the
battery terminal to the battery
manufacturer’s torque
requirement.
CONNECT SECOND:
Positive (+) (red) Cable from
the Battery Box to the Inverter*
CONNECT FIRST:
Negative (–) (black) Cable from
the Battery Box to the Inverter*
If using one battery......
*These cables are connected
to the Anderson Plugs in the
front panel of the battery box.
If using two batteries, see
Figure 3-6 for additional
cabling instructions.
Split Washer
Cable from Battery Box
Battery Terminal
Cable Connection Order:
Hex Nut
DISCONNECT FIRST:
Positive (+) (red) Cable from
the Battery Box to the Inverter*
DISCONNECT LAST:
Negative (–) (black) Cable from
the Battery Box to the Inverter*
Important:
When disconnecting
batteries, ensure all incoming power
has been disconnected.
Then remove the Positive (+) (red)
cable FIRST , and the negative (–)
(black) cable LAST.
975-0289-01-01(PowerHub_1800_IG).book Page 4 Thursday, June 4, 2015 9:49 AM