Page 4
Model RS232IR
© 2002 Xantech Corporation.
3.
Figure 1
also shows a 291-10 IR Receiver as an optional item. You could use this to test IR commands on
the controlled equipment through the IR system before they are learned and programmed by Dragon Drop-IR,
if programming IR.
Setup Switches
1. Write/Protect Switch. Up is ‘Write’, Down is ‘Protect’. Must be in ‘Write’ position for programming. Protect
position prohibits programming and protects all stored data from unintentional erasure.
2. Network Address Switch. Has no function in this product. Should be left in factory default ‘0’ position.
3. Restore Switch. Resets unit to restart operation after errors, lockups, etc. Does not erase user programmed
commands.
SOFTWARE INSTALLATION
The installation software for the Dragon Drop-IR system is included in the supplied CD ROM. Install the Dragon
Drop-IR™ Software onto your hard drive as follows:
Windows 95/98/NT/2000/ME/XP
1. Insert the DRAG460 beta CD into your CD-ROM drive. If your drive has been set for auto run, a ‘Xantech
Welcome’ menu will appear. If not, access your CD ROM with Windows Explorer and double click
"autorun.exe".
2. On the Welcome menu, click Install DD460 Software.
Follow the on-screen instructions as the program installs. It takes approximately one to three minutes to
complete, depending on the speed of your machine.
NOTE:
For the convenience of the installer, the Dragon Drop-IR CD ROM contains a complete set of
Application Notes, the Xantech Product Catalog, Factory Learned IR Codes, web site browsers and important
notes. Read the Very Important Notes first, click on the desired menu item and follow the on-screen
instructions.
STARTING DRAGON DROP-IR
Windows 95/98/NT/2000/ME/XP
1.
Installation creates a shortcut on the desktop. Double click on the DRAG460 Shortcut or:
2. From START menu, choose Programs.
3. Select DRAG460 from the list and click on the DRAG460 Icon.
4. The program loads and opens to the Xantech Dragon Drop-IR opening screen.
SERIAL PORT SELECTION
When first launched, the Dragon Drop-IR software scans the serial ports and will display the available ports under
"Preferences" in the File menu. Unavailable ports will be grayed out. Com Port 1 would normally be used, but if it
is already in use, it will be necessary to use a different one. If your computer only has a USB connection, a USB
to Serial Adapter (including software) can be purchased at most computer stores and is available for purchase
from Xantech. (Also check with local Authorized Xantech Distributor).
Select the Com Port as follows:
1. Click “PREFERENCES” (F2) from the File menu.
2. Click on an available port, then OK.
PROGRAMMING PROCEDURES
PLANNING THE SYSTEM
Before attempting any programming, plan the system configuration first. This should include the following:
a) Determine the brands and types of all IR-controlled components you expect to use.
CAUTION:
See caution card (included) for the latest information regarding code compatibility before
finalizing the system.
