- 6 -
Locating the RF2IR2W
Thanks to Xantech’s superior antenna design, the RF2IR2W can be placed in several locations.
Key Location Points:
•
The RF2IR2W should be placed on a flat, stable surface.
•
For optimal performance, the RF2IR2W should be placed at a height greater than 3 feet above the
floor. The ideal height should be level to the XTR39 transmitter.
•
Avoid placing the RF2IR2W near corners of a room.
•
Avoid placing the RF2IR2W next to microwave ovens.
•
Using a lower Channel Address will provide the best performance.
Care and Maintenance
Clean the outside of the plastic housing using a soft cloth. Use warm water and mild soap solution.
Do not use abrasive cleaners.
Information
FCC NOTICE
* Section 15.19 Labeling requirements
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received,
including interference that may cause
undesired operation.
* Section 15.21 Information to user
The changes or modifications not expressly approved by
the party responsible for compliance
could void the user’s authority to operate the
equipment.
* IMPORTANT NOTE: To comply with the FCC RF
exposure compliance requirements, no change to the
antenna or the device is permitted. Any change to the
antenna or the device could result in the device
exceeding the RF exposure requirements and void
user’s authority to operate the device.
0197
RF2IR2W RF Base Station Quick Start Installation Instructions
© 2008 Xantech Corporation
This document is copyright protected. No part of this manual may be
copied or reproduced in any form without prior written consent from
Xantech Corporation.
Xantech Corporation shall not be liable for operational, technical, or
editorial errors/omissions made in this document.
Document Number 08905185A
