![background image](http://html1.mh-extra.com/html/xantech/mrc88/mrc88_quick-start-manual_3168160019.webp)
MRC88 / MRAUDIO8X8 QUICK START GUIDE
08905142A
19
ZONE AUDIO ADJUSTMENTS (MRC88 Keypad – User Settings)
To adjust Treble, Bass and Balance from a MRC88 Keypad:
1.
Simultaneously press the
Status
and
VOL+ Buttons
. The ‘
Audio Setup
Mode
’ will appear on the
keypad LCD
.
2.
To adjust
Balance
, press the button under
‘BAL’
. The
‘<’ REW Button
will
shift audio to the
left speaker
. The
‘>’ FF Button
will shift audio to the
right
speaker
. The
Select/Play Button
will restore
center balance
. Display will
return to normal after 10 seconds of no activity.
3.
To adjust
Treble
or
Bass
, press the appropriate button in the LCD Display.
The
‘<’ Button
will
decrease
the amount of treble or bass. The
‘>’ Button
will
increase
the treble or bass. The
Select/Play Button
will restore the audio to
the
‘flat’
setting. Display will return to normal after 10 seconds of no activity.
NOTE:
These adjustments do not affect Z-ADJUST default settings.
AUDIO ADJUSTMENTS (Z-Adjust – Installer Settings)
These settings are ‘permanent’ settings that will affect system or zone
performance whenever the system is turned on, (even after a power outage) until
the settings are changed using the following procedure:
Trim
This procedure adjusts the MRC88 Source Input levels to compensate for the
different output levels of the common sources. When this procedure has been
properly executed, the audio level of the common sources should be the same
when switching from one source to another.
With all sources ON and playing relatively similar program material:
1.
Cycle through the inputs to get a reference to the relative audio levels of the
different sources.
2.
Using an
RC68X
with overlay
“A”
,
select the input that has the lowest
apparent volume level
(from any zone).
3.
Point the
RC68X
at the
IR sensor
on the
MRC88 Keypad
(IR sensor
enabled) and press the
Trim Button
(button F8). This activates the Trim
mode.
NOTE:
Trim mode allows 10 seconds after each button press for the next
command to be executed. If 10 seconds is exceeded, simply press Trim
again. To confirm Trim mode, press the
Mute ON Button
. If the sound
mutes, the MRC88 Controller is
NOT
in the Trim mode.
4.
Select any other input that sounds louder.