®
6
TV MOUNT ADAPTER
The TV Mount Adapter allows mounting the IR Receiver on an
extension attached to the rear or side panel of a flat panel TV that does
not have a frame on the front that is wide enough to directly mount the
IR Receiver. This application can also be used to mount the IR Receiver
in just about any position on just about any object.
Both ends of the TV Mount Adapter rotate and swivel allowing the
Adapter and IR Receiver to be manipulated into different positions as
shown in
Figure 4
.
1.
Select a location on the TV to mount the TV Mount Adapter. Be
sure that once mounted, the IR Receiver will not be blocked by any
object to allow ‘line-of-sight’ to the remote control in normal use.
2.
Using one of the included adhesive strips, attach the flat end of the
TV Mount Adapter to the TV frame.
Figures 2 & 3 & 5
3.
With the 8” Ribbon Cable aligned to the Wire Gap on the ridged
end of the TV Mount Adapter,
(Figure 5)
using one of the included
adhesive strips, attach the IR Receiver to the TV Mount Adapter.
Figures 2 & 3
4.
Carefully flatten and wrap the 8” Ribbon Cable around to the back
of the TV. The Ribbon Cable can be secured to the TV with tape or
a wire holder if necessary. Do not block any TV vents.
5.
Using one of the included adhesive strips, attach the Electronics
Module to the rear of the TV. Do not block any TV vents.
Figures 2 & 3
6.
Carefully flatten and wrap the plug end of the Ribbon Cable into
the cabinet with the A/V components. Be careful not to pinch or
strain the Ribbon Cable. The Ribbon Cable can be secured to the
back of the TV with tape or a wire holder. Do not block any TV
vents. If this is your application, when finished, proceed to section:
Typical Connections
.
Front of TV
EN85
IR Receiver
EN85
Electronics Module
To Connecting
Block
RCVR Jack
Attach with Adhesive
Attach with Adhesive
8” Ribbon Cable
EN85
TV Mount Adapter
Flat
End
Ridged End
Figure 2 -
TV Mount Adapter -
Rear Mount
Front of TV
EN85
IR Receiver
EN85
Electronics Module
To Connecting
Block
RCVR Jack
Attach with
Adhesive
Attach with Adhesive
8” Ribbon Cable
EN85
TV Mount Adapter
Attach with
Adhesive
Flat End
Ridged End
Figure 3 -
TV Mount Adapter -
Bottom/Side Mount
Flat End
Ridged End
Wire
Gap
360°
180°
Figure 4
Figure 5