®
5
INSTALLING THE IR RECEIVER
SURFACE MOUNT
The first, and easiest, option is to mount the IR Receiver on the front frame of a
flat panel TV. This application can also be used to surface mount the IR Receiver
to other objects.
1.
Select a location on the TV frame to mount the IR Receiver. Be sure the
receiver will not be blocked by any object to allow ‘line-of-sight’ to the
remote control in normal use.
2.
With the IR Receiver 8” Ribbon Cable directed toward the edge of the TV,
using one of the included adhesive strips, carefully attach the IR Receiver to
the TV frame.
Figure 1
3.
Carefully flatten and wrap the 8” Ribbon Cable around to the back of the
TV. The Ribbon Cable can be secured to the TV with tape or a wire holder if
necessary. Do not block any TV vents.
4.
Using one of the included adhesive strips, carefully attach the Electronics
Module to the rear of the TV. Do not block any TV vents.
5.
Carefully run the plug end of the Ribbon Cable into the cabinet with the A/V
components to where the Connecting Block will be located. Be careful not
to pinch or strain the Ribbon Cable. The Ribbon Cable can be secured to
the back of the TV with tape or a wire holder. Do not block any TV vents.
If this is your application, when finished, proceed to section:
Typical
Connections
.
Figure 1 -
Surface Mount - Flat Panel TV
Front of TV
EN85
IR Receiver
EN85
Electronics Module
To Connecting
Block
RCVR Jack
Attach with
Adhesive
Attach with
Adhesive
8” Ribbon Cable